Take our FREE 3D Art Courses! Click here.

TIPS & TRICKS

  • Gather your IDO3D© materials needed: Pen, IDO3D© Light, Clear sheet for tracing artwork.
  • Open your Pen and remove the safety seal and install the cap. 
  • Trace artwork using the Clear sheet. 
  • PRO TIP: Draw short sections of artwork and hit with light to keep the finest detail. Continue this process until piece is finished. 
  • Use your IDO3D© Light to cure your artwork for 30 seconds.     
  • PRO TIP: The closer you hold the IDO3D© Light to your artwork the quicker it will dry. 
  • Apply more IDO3D© ink to the connecting pieces
  • Use your IDO3D© Light to cure your connecting artwork for .30 seconds.

Attaching the Light:

Its easy! Two steps:

  1. Turn light sideways
  2. Push pen into light firmly and twist 1/4 of a turn clockwise

ADDITIONAL TIPS

1. YOU CAN CURE ARTWORK FROM BOTH SIDES OF THE TRACING SHEET. 
2. TRACE OVER THE TOP OF YOUR ARTWORK TO ADD THICKNESS AND STRENGTH. 
3. IDO3D© INK SELF-LEVELS AND SPREADS IF YOU ALLOW IT TO SIT BEFORE CURING.
YOU CAN FILL IN LARGE SECTIONS OF ARTWORK BY ALLOWING THE INK TO SPREAD. 

4. STICKY RESIDUE CAN BE EASILY REMOVED FROM HANDS BY USING HAND SANITIZER.

IDO3D GO!

GO! is the latest IDO3D product line, that allows you to use America’s favorite 3D drawing pen to create your own moving 3D works of art.  As with any new art medium, there is a learning curve and everyone learns at a different pace. Don’t worry, you'll get better with practice!

Special Tips for GO!:

  1. Draw small pieces of your project and quickly passover it with your pen light to prevent the ink from dripping. 
  2. Some pieces are easiest to create if you draw and cure the outline first and then come back and fill in the piece. 
  3. Thick areas of ink may require curing from the top and bottom of the piece. 
  4. The most important step in getting your artwork to stick to the mechanism is making sure that the ink fully cures.
  5. When attaching your project pieces to the mechanism, start by applying a SMALL dot of ink, then FULLY harden with your IDO3D pen light
  6.  The more surface area that the ink covers, the better the bond. 
  7. Avoid getting ink into the joints and or pivot points of the mechanisms, as this will prevent your project from moving freely.